Specially formulated compound for removing biofilm that forms in the circuits (pipes) of spas and whirlpool tubs.
Fill the spa or whirlpool tub with water up to 5-10 cm above the delivery nozzles. The same bath water can be used.
Add half a bottle (500 ml) of Pipework Cleaner to remove biofilm from spas or whirlpools of 1,000-3,000 litres.
Remove the filter cartridges before cleaning and run the filtration and massage pump for about 30 minutes.
Once cleaning is complete, the spa or hot tub should be emptied and then refilled with clean water for rinsing by running both pumps (filtration and massage) for 1 - 2 minutes. After this time, empty the glass again.
Finally place the cartridge (new or clean) back in the filter and fill with clean water with disinfectant (chlorine or bromine).
It is forbidden to bathe during the cleaning process.
A spa or whirlpool tub should be cleaned about 3-4 times a year.
|75984||CTX-943 Pipework Cleaner 1l|