CTX-596 PhosFree
Élimine l'excès de phosphates dans l'eau
- Compatible avec tout type de désinfectant
- Améliore le rendement de l’électrolyse au sel
- Avec bouteille de dosage, facile à utiliser.
- Une concentration de phosphate doit être maintenue inférieure à PPB 25 pour éviter la formation d'algues
Élimine l'excès de phosphates dans l'eau. Il est compatible avec toute sorte de désinfectant, facile et simple à utiliser, et en plus il améliore le rendement de l’électrolyse au sel (un traitement désinfectant très efficace pour les piscines, basé sur la transformation des doses de sel en hypochlorite de sodium à l’aide d’un courant électrique continu).
| RÉFÉRENCE | Description |
|---|---|
| 159601CTX | 1 l |
MODE D´EMPLOI
STEP 1 : Hold the bottle upside down so that the dosing chamber can be filled.
STEP 2 : Unscrew the cap of the bottle.
STEP 3 : Empty the dosing chamber.
"SPECIFIC USE". : For a specific volume, tilt the bottle and determine the desired dosage.
DOSAGE
Initial treatment: (for high phosphate levels)
1. Perform a phosphate level analysis of the pool water using a Phosphate Kit.
2. Clean the filter.
3. Calculate the amount of product needed (using the following dosage table), pour the dose of product
directly into the pool tank and spread it evenly over the surface of the pool.
4. Keep the filtration system running for at least 24 hours (If the filter pressure increases by more than 10 PSI,
perform a filter cleaning).
5. After 48 hours, test the phosphate level with a phosphate kit. If necessary, repeat the treatment with
PHOSFREE.
Note: The use of PHOSFREE may cause turbidity to the pool water in the initial phase. This is normal and indicates that the product is working, it will disappear in a few minutes.
Amount of phosphates in your pool
Volume of the pool 250 ppb 500 ppb 1000 ppb 1500 ppb
25 m3 75 ml 150 ml 300 ml 450 ml
50 m3 150 ml 300 ml 600 ml 900 ml
Maintenance treatment: With the filtration equipment running and without the presence of swimmers in the pool, add 60 ml. of product per 50 m3 of water every week, to maintain phosphate levels below 125 ppb (parts per billion).
These doses are the ones suggested and can be modified according to the own characteristics of every
swimming pool, climate, etc.